Skip to main content

How to Install Your RiderNav R7X on Your Motorcycle

Start your motorcycle, insert the R7X into the cradle (RiderNav logo at bottom-left), and confirm it powers on and locks securely. Press the release pin to remove.

Start your motorcycle, insert the R7X into the cradle with the RiderNav logo at the bottom-left, and confirm it powers on and locks. Press the release pin to take it off.


Step 1: Mount the Bracket

Before you start:

  • Pick a mounting location with a clear view of the screen and within reach while riding.

  • Do not block instruments, gauges, or steering.

RiderNav does not support installing the R7X on a third-party mount. Use the official R7X mount / bracket.

Install the bracket:

  1. Identify your handlebar diameter — measure the circumference of your handlebar.

  2. Select the correct diameter adapter — the included bracket fits round handlebars with a diameter of Φ22-32 mm. Choose the adapter ring that matches your handlebar size.

  3. Secure the bracket — attach it to the handlebar using the selected adapter.

  4. Tighten all screws firmly — use the provided screwdriver so the bracket does not move while you ride.


Step 2: Connect to Power

The R7X power cable has three wires:

Do not skip the yellow ACC wire, and do not power the R7X from the battery alone.

Important: Make every connection secure and insulated so you do not create a short circuit.


Step 3: Power Check and Securing the Unit

Step 3.1 – Power On Test

  1. Start your motorcycle.

  2. Insert the R7X into the quick-release cradle on the bracket.

  3. Confirm the R7X powers on.

Correct orientation: Line the display up with the cradle before you insert it. The RiderNav logo should appear at the bottom-left of the screen.

Step 3.2 – Secure Seating Verification

  1. Gently push and pull the R7X to confirm it is seated and locked in the cradle.

  2. The unit should not wobble or slide.

Step 3.3 – Removal (When Needed)

  1. Press the release pin on the cradle to detach the R7X.

  2. Hold the unit firmly while you release it so it cannot fall.


Safety Reminders

  • The mount must not obstruct your view or block critical controls.

  • Double-check every screw before your first ride.

  • Confirm the power connections are secure and insulated.

  • Hold the R7X carefully when inserting or removing it so it does not drop.

Did this answer your question?