Skip to main content

Powering Your R7X: Alternative Connection Methods When Fuse Box Access Is Unavailable

If you cannot access the fuse box, connect the R7X yellow ACC wire to the tail light power wire. The red and black wires still go to the battery. Do not power the R7X from the battery alone.

For daily riding, power the R7X using the three-wire method: red and black wires to the battery, and the yellow wire to ACC (switched power). Do not power the R7X from the battery alone. If you cannot access the fuse box, connect the yellow ACC wire to the tail light power wire as described below. Do not use USB as everyday riding power. USB may be used only for temporary testing or for OTA firmware updates.

Where to Find the Tail Light Wiring:

The tail light electrical harness is typically routed through one of these locations depending on your motorcycle model:

  • Inside the rear fender assembly

  • Behind or under the seat area

  • Adjacent to the tail light housing

  • Within the rear frame structure

Steps to Connect the R7X Yellow ACC Cable

  1. Access the tail light area – Remove your seat and any rear panels necessary to reach the tail light wiring bundle.

  2. Locate the tail light housing – Find where the tail light connectors and wires are housed, and carefully expose the wiring.

  3. Identify the power wire – Using a multimeter set to voltage mode, test the individual wires in the harness to locate the one that carries positive voltage to the tail light circuit. This is your ACC power source.

  4. Connect the R7X yellow cable – Securely splice or crimp your R7X's yellow ACC cable to this identified power wire, following proper electrical safety practices. The red and black wires still go to the battery.

This method ensures your R7X receives stable power synchronized with your motorcycle's lighting circuit. This is an ACC / yellow-wire connection for daily riding, not a substitute for the battery connections. For the full three-wire method and USB test limits, see How to properly connect the R7X power cable to your bike’s ACC wire.

Did this answer your question?